JeepGrand Cherokee2005
  1. Jeep Grand Cherokee
  2. Problems
  3. 2005
  4. Wiring

2005 Jeep Grand Cherokee Wiring Problems

4
Owner complaint records in our dataset

Records are owner complaints, not a measured failure rate.

Owner complaint recordsComplaint records reflect reports in our dataset and do not measure how frequently the problem occurs across all vehicles.

Mileage in stored records

BandRecords
1–30k mi2
30–60k mi1

Complaint records

Owner-submitted complaint content, presented as stored.

  • November 26, 2007 · 32,600 miles

    Air Conditioner · Wiring

    Tl*the contact owns a 2005 jeep grand cherokee. The air conditioner would only function properly when on a high setting. The repair shop stated that the wire harness for the blower motor was melting and causing the failure. The dealer stated that a new blower and wire harness was needed. The current and failure mileages were 32,600.

    ODI 10210069

  • April 1, 2006 · 15,550 miles

    Automatic Transmission · Vehicle Speed Control · Wiring

    Dt*: the contact stated in april 2006, the vehicle accelerated on its own nearly causing an accident. The service dealer determined the computer system that runs the transmission was the problem. The computer issue allowed the transmission to leak improperly. Also, in october 2006 the vehicle stalled at 30 mph due to all the electric in the vehicle failing.

    ODI 10171007

  • September 28, 2005

    Wiring

    It all started with the seats not staying in there settings(driver 1 driver 2. Then the auto dimming rear mirrors would go dark at any time. The rain sensor wipers stopped working. The car would accelerate on it own. Even when in park, then the seats started moving to driver 1 then 2 as i was driving it. The jeep also has a bad odor in it. It is at the dealer as i speak, the jeep is not safe to drive. Fog light go…

    ODI 10138142

  • July 20, 2005 · 5,770 miles

    Air Conditioner · Fan · Wiring

    Dt: consumer owned a 2005, jeep , grand cherokee laredo. The air condition had a part that needed to be replaced on 7-18-05. And later on 7-20-05 the blower fan and heater would only work on the highest setting. A part melted, and there were too many amps being driven to the resister. They had to the replace blower motor, relay, resister, and a wire harness. *ak

    ODI 10129500